SEPTICTRINE : · Natural enzyme septic tank cleaner.

BEST FOR:

4 SEPTIC SYSTEMS	4 OPEN VAULT OR TANK TOILETS	4 DUMPING STATIONS
4 DRAIN FIELDS	4 ON-SITE SEWAGE DISPOSAL	4 SEEPAGE DITCHES
4 CESSPOOLS	4 COMPOST PILES

FOR USE IN:

4 Septic Tank	4 Pit Toilets	4 Bathrooms, Kitchen & Laundry Room Drains
4 Drain Fields	4 RV Holding Tanks	4 Dumping Stations

SEPTICTRINE is a combination of 5 natural enzymes including protease, lipbase, pectinase, cellulase and amylase. These enzymes were selected specifically for their ability to digest the common problem-causing organic wastes from humans, animals and plants.

Use of SEPTICTRINE will:
~ Reduce septic tank pumpouts
~ Control odours
~ Reduce drain field glazing
~ Restore parcolation
 

NOTICE:
Neither the manufacturer nor the seller makes any warranty, expressed or implied, concerning the use of this product other than indicated on the label. Buyer assumes all risk of this material which is contrary to the label.

DIRECTIONS:
SEPTIC Tanks: Use 2oz.SEPITCRINE per 500 gallons tank capacity once a week until system is cooperative. Troublesome systems might benefit from an initial shock treatment of 1 to 3lbs SEPTICTRINE. Then add maintenance treatment of 2 ounces every 2 weeks. Apply by flushing down toilet or drain.

Cesspools/ Dumping Stations: Following directions for septic tanks. Apply SEPTICTRINE directly into systems.

RV Holding Tanks: Flush 2 ounces SEPTICTRINE and 1 gallon water into tank. Repeat after every dumping.

Drain Fields: For each 500 square feet of field, dilute 2 ounces SEPTICTRINE with 10 gallons water. Sprinkle or spray directly over filled surface. An additional application can be made by adding 2 ounces SEPTICTRINE to distribution box between septic tanks and field.

Kitchen, Bathroom, Laundry Room Drains: For slow drains, flush 2 ounces SEPTICTRINE with 1 cup lukewarm water down drain. Best results are obtained by applying at night when drains is not in use. Repeat results once a month or as needed.

CAUTION: Hot water destroys action. Use only lukewarm water

PACKING: 3 lb Bucket
 

BESTCHEM OCTOPUS LIQUID LEAK DETECTOR : LIQUID LEAK DETECTOR

SIMPLE & EASILY DETECT GAS LEAKS IN HARD TO REACH AREAS

DESCRIPTION:
BESTCHEM OCTOPUS help to locate rapidly and oaccurately any leaks in:

4 Pipelines under pressure (compressed air, oxygen and combustible gases)

4 Pressurised containers and compressor installations.

4 Safely use on pressurised combustible gas pipelines.

4 No danger of explosion.

DIRECTIONS:
~ Remove cap from plastic bottle and gently squeeze a small amount to the area to be tested.
~ Watch for glowing bubbles.
~ Bubbles will form immediately, indicating the leak position.

PACKING:
* 250 ml bottle
* 1 ltr container
* 1 gall container
 

BESTCHEM HIGH QUALITY SILICAGEL

A high capacity absorbent & desiccant amorphous form of silica made from sodium silicate & sulphuric acid. It has an almost infinite number of sub-microscopic pores or capillaries which attract water & other vapour condense them & hold absorption & capillary condensation.
 

EXCELLENT PHYSICAL STRENGTH

BESTCHEM HIGH QUALITY SILICAGEL is basically a rugged material having hardness No. 5 on Moh's

MAXIMUM RESISTANCE TO FOULING
Becase BESTCHEM HIGH-QUALITY SILICAGEL is high purity silica, it exihibits extreme chemical inertness against almost all chemicals except strong alkalies and hydrofluoric acid, which is a major factor in resistance to fouling.

Uses:
Dehumidifying and dehydrating agent: airconditioning, drying of compresses air & other gases, liquids, such as refrigerants, and oil containing water suspension: recovery of natural gasoline from natural gas, blenching of petroleum oils; catalyst and catalyst carrier: chromatography: anticaking agent in cosmetics and pharmaceuticals: in waxes to prevent slipping.

IMPORTANT:
BESTCHEM HIGH QUALITY SILICAGEL absorbs moisture from the air: therefore always replace
lid and store in dry place.

BESTCHEM HIGH QUALITY SILICAGE
M11-D-3464

CHEMICALS ANALYSIS

CHEMICAL COMPONENTS	BLUE GEL		PHYSICAL PROPERTIES	BLUE GEL
SIO2	97.7		Bulk Density g / ml	0.75
FE2O3	0.02		Surfaced Area m2 / g	700
AI2o3	0.17		Pore Volume	0.40
NA2O	0.23		Ph ( at 25o C)	5.3
			Ignition Loss (%)	7.4

MOISTURE ABSORPTION CAPACITY

RELATIVE HUMIDITY BLUE GEL	BLUE GEL
R.H 20%	13.0		PACKING:
R.H 50%	25.0		a) In desiccant bags of various size.
R.H 90%	36.0		b) In 1 kg can
NA2O	0.23		c) In 25kg drum.

 

SC 1000 AQUEOUS CLEANER CONCENTRATE

FOR CLEANING:

SC 1000 AQUEOUS CLEANER CONCENTRATE is a versatile and powerful cleaner used in a variety of industrial and commercial applications. The powerful micelle cleaning action SC 1000 will cause long change hydrocarbon soils including fats, greases, oils and sugars to repel from the surface so that it can rinsed away with water, without damaging or reacting with the cleaning surface. SC 1000 is not a solvent, typical caustic detergent or petroleum therefore it will not damage or react with the cleaning surface.

PACKING:
~ 4 LITRES CONTAINER
~ 20 LITRES CARBOY
~ 200 LITRES DRUM

CALIBRATED EZTM ZAHN (ASTM) CUP VISCOSITY CUPS

3% GUARANTEED TOLERANCE
COMPLIES WITH & EXCEEDS ASTM D 4212
THE FINEST, MOST RELIABLE, CALIBRATED & DOCUMENTS CUP ON THE MARKET!

The EZ CUP:

• matches the applicable ASTM formula in D 4212 at the recommended calibration level.

• compatible to ASTM D 1084 viscosity of adhensives and ASTM D 816.

• traceable to the National Institute of Standards and Technology calibration and certification procedures qualify under ANSI/NCSL Z540-1 or MIL STD-45662A as applicable.

• highest qulaity of workmanship or in continuing quality control procedures.

• all stainless steel cup and handle.

• produced to very close mechanical tolerance in elaborate jigs and fixtures.

TRITON™ SURFACTANTS

TRITON® X-100 NONIONIC SURFACTANT

Product description :

TRITON® X-100 is a water-soluble, liquid, nonionic surfactant that has come to be recognised as the
performance standard among similar products. It is an octylphenol ethoxylate with an average of nine
to ten moles of ethylene oxide and is a 100-percent active product.

PERFORMANCE PROPERTIES
Solubility and Compatibility
TRITON® X-100 Nonionic Surfactant is soluble at 25oC in all proportions in water, toluene xylene, trichloroethylene, ethylene glycol ethyl ether, ethyl alcohol, isopropyl alcohol, ehtylene dichloride, and many other solvents. It is insoluble in kerosene, mineral spirits, and VM&P naptha, unless a coupling agent is used. Oleic acid is an effective coupling agent in systems based on kerosene. Solutions containing up to 5 percent TRITON X-100 in 40 percent phosphoric acid or 30 percent hydrochloric acid are stable for at least 48 hours at room temperature.

TRITON X-100 is compatible with anionic, cationic, and nonionic, surface-active agents. Like other alkylaryl polyether alcohols, this surfactant will discolor on dry caustic and anhydrous metasilicate. However, it can be used in formulations containing moderate quantities of these alkalis with sufficient stability, It is completely stable in liquid formulations containing sodium hydroxide, showing no change in color or physical properties, and in the presence of mild, alkaline builders normally used in the preparation of metal cleaners and cleaning compounds
 

Detergency
TRITON X-100 is a highly effective detergent. It is effective in textile cleaning applications and is used in
" built" formulations designed for home and industrial laundering.

Hard-Surface Cleaning
TRITON X-100 offers exceptional performance in hard-surface cleaning applications in a metal cleaning application. TRITON X-100 was compared to TRITON N-101. For this test, steel test panels were soiled with a heavy primary motor oil ("Brightstock") and cleaned in a bath with a heavy-duty, alkaline detergent containing TRITON X-100 or TRITON N-101 surfactants. Figure 1 shows the percent cleaning obtained versus surfactant concentration. TRITON X-100 Surfactant delivers 90 percent cleaning efficiency at less than half the concentration required by TRITON N-101 to reach the same cleaning efficiency.

SUPER SEVEN - AIRPLANE WASH

SUPER SEVEN AIRPLANE WASH is a new concept in chemical cleaners for all phases of cleaning, dispersing, emulsifying and handling of virtually any type of grime or contaminants including petroleum based products. Its easy application makes in an even popular airplane wash. Simply spray onto the dry surfaces, rub in and rinse off.

SUPER SEVEN is designed to be the most economical and environmentally safe cleaner in today's market.

Also, SUPER SEVEN cleans mildew, creosote, carbon dust, drilling mud, grease and dirt on floors, walls, stainless steel, parts & shop machinery, #6 oil and circuit boards.

SUPER SEVEN IS:

4 Highly biodegradable	4 Dilatable with either fresh or salt water
4 Non-flammable	4 VOC's nil to none
4 Phosphate free	4 No Ozone Depleting chemicals
4 Non-toxic

SUPER SEVEN is non-hazardous in nature and does not require any EPA Registration or Coast Guard Certification for use in ship's store on board vessels as its characteristics do not represent sufficient hazard to be considered a dangerous article under 46-PFA-147.

Dilution
For cold or hot cleaning
Normal cleaning - 10 to 20 parts of water to 1 part of SUPER SEVEN
HEAVY DUTY CLEANING - 5 to 10 parts of water to 1 part of SUPER SEVEN
Extra heavy duty cleaning - 3 to 5 parts of water to 1 part of SUPER SEVEN
Steam clean or pressure wash - 5 to 350 parts of water to 1 part of SUPER SEVEN

BESTCHEM RUNWAY RUBBER AND OIL REMOVAL (Type BC-780)

Description
Bestchem Runway Rubber Removal BC-780 is a concentration of liquid non-ionic and anionic biodegradable surfactants blended with enhancing environmentally safe citrus solvents. It is designed to provide maximum surface action to remove oil, grease and reverted rubber into dispersions suspensions and emulsions with water

Features:

4 Fast Acting
4 Highly Effective
4 Environmentally Safe
4 Economical

Uses

Application
Bestchem Runway Rubber removal BC-780 is sprayed onto contaminated areas at a rate of 0.25 litres per square meter. After soaking for four to five minutes the area is brushed to agitate the liquid and then pressure sprayed with clear water. For large areas we recommend that the emulsion is extracted by suction.

For oil spills are on concrete, just spray Bestchem Runway Rubber removal BC-780 onto the spills and agitate with a brush and the surface colour will change to a brown tint. Use plenty of water to hose this slurry away, or preferably suction it away, and the area can then be immediately opened to traffic. If it is done thoroughly, the surface should not be slippery.